This wizard screen allows you to set up a coordinate system rotation for an automatic coded target project based on the coded target identifiers. This pane will only be displayed if you check the activate check box on the previous pane (Project Wizard: Scale/Rotation (Automated Coded Targets Project)).
Activate two of the axes and enter the coded target IDs of the points that define them. This is similar to the scale/rotate settings in the Imports and Coordinate Systems Pane. The Next button will enable only when 2 axes are defined (you cannot define all 3).
Note that the numbers entered here are the code numbers for the coded targets and not the Point IDs seen on same targets after a project is done. Code numbers are printed on the coded target paper in a small font. For example, a target that might have code number 5 (“5” is shown on the printed coded target sheet), when the project is complete the point might have the ID 1005 or 2005. Coded points and non-coded points are kept distinct by placing them into their own thousands series. “5” is the number that would be entered in this dialog if that was the target of interest.